What is a decibel (dB)?
A decibel (dB) is the unit used for sound levels. It is logarithmic: it compares a sound pressure with a reference value, so equal proportional changes in pressure give equal steps in decibels. The threshold of hearing is about 0 dB, and a typical new build classroom limit is 35 dB LAeq,30min.[1][2]
Key points
- The decibel scale is logarithmic, so levels cannot be added in the ordinary way.[1]
- Two identical sounds heard together are only 3 dB louder than one, and an increase of 10 dB normally represents a doubling of perceived loudness.[1]
- The threshold of hearing is about 0 dB, which corresponds to a reference sound pressure of 2 x 10-5 Pa, and the threshold of pain is around 140 dB.[1]
- BB93 sets upper limits in decibels for indoor ambient noise, for example 35 dB LAeq,30min in a new build primary classroom.[2]
How it works
Sound is a pressure fluctuation in air. The Institute of Acoustics and the Association of Noise Consultants explain that levels are quoted in decibels relative to a reference value, and that the scale gives equal values to proportional changes in sound pressure.[1] An increase in sound pressure from 1 to 2 Pa sounds the same to the ear as an increase from 10 to 20 Pa.[1] The logarithmic scale also compresses the very wide range of pressures the ear meets into a manageable range of numbers.[1]
Sound power, the total acoustic energy a source radiates each second, can also be given in decibels, referenced to 1 x 10-12 W.[1]
The numbers
- Combining two levels A dB and B dB: C = 10 lg (10^(A/10) + 10^(B/10)) dB.[1]
- Two identical sources together: the total is 3 dB higher than one source.[1]
- An increase of 10 dB normally represents a doubling of perceived loudness.[1]
- Threshold of hearing: about 0 dB; threshold of pain: around 140 dB.[1]
- WHO guidelines for community noise recommend less than 35 dB(A) in classrooms to allow good teaching and learning conditions.[3]
In schools and SEN settings
BB93, the Department for Education's guidance on school acoustics, states its indoor ambient noise limits in decibels: 35 dB LAeq,30mins for a new build nursery, primary or secondary classroom (40 dB for refurbishment), and 30 dB for a teaching space intended specifically for students with special hearing and communication needs (35 dB for refurbishment).[2] Because the scale is logarithmic, a gap of 5 dB between a refurbishment and a new build limit is a real difference in level, not a rounding step, and the guide notes that an increase in 10 dB normally represents a doubling of perceived loudness.[2][1]
Worked example
These figures are illustrative. Suppose a classroom has a ventilation hum of 35 dB and a projector fan of 35 dB, both measured in the same position.[1] Combined: 10 lg (10^3.5 + 10^3.5) = 10 lg (2 x 3,162) = 10 lg 6,325 = 38 dB, which is 3 dB above either source alone.[1] A second case: a 40 dB source and a 30 dB source give 10 lg (10,000 + 1,000) = 10 lg 11,000 = 40.4 dB, so the quieter source adds almost nothing.[1]
What people get wrong
- Adding decibels like ordinary numbers. 40 dB plus 40 dB is 43 dB, not 80 dB, because levels combine through the equation above.[1]
- Treating 3 dB as barely worth having. A 3 dB change is a halving or doubling of sound energy, even though a 10 dB change is needed for the ear to judge a doubling of loudness.[1]
- Quoting a bare number. A figure in dB means little without the descriptor (LAeq, LA90 and so on), the time period and the weighting, which is why BB93 writes LAeq,30mins.[2][1]
How it is measured
A sound level meter measures sound pressure level and expresses it in decibels. Meters average over short intervals set by international standards, and the guide gives the usual time constants as fast (125 ms) and slow (1 s).[1] The performance of the instrument itself is specified in IEC 61672-1, which defines two categories, class 1 and class 2.[4]
FAQ
What does 0 dB mean?
It is the approximate threshold of hearing, corresponding to a reference sound pressure of 2 x 10-5 Pa, not the absence of sound.[1]
Why does doubling the number of noise sources only add 3 dB?
Doubling the sound energy raises the level by 3 dB because the scale is logarithmic.[1]
Is dB the same as dB(A)?
No. dB(A) is a decibel level after a weighting that approximates the frequency response of the ear.[1]
What decibel level is recommended for a classroom?
WHO guidelines recommend less than 35 dB(A) in classrooms, and BB93 sets 35 dB LAeq,30mins as the new build limit for most classrooms.[3][2]
WorkSpace Acoustics surveys and installs acoustic treatment; contact the team to talk about a room.
Sources
- Acoustics of Schools: a design guide. Institute of Acoustics and Association of Noise Consultants, November 2015. Accessed November 2026.
- Acoustic design of schools: performance standards (Building Bulletin 93). Department for Education, February 2015. Accessed November 2026.
- Noise. World Health Organization Regional Office for Europe, no date shown on the page. Accessed November 2026.
- IEC 61672-1:2013 Electroacoustics: Sound level meters, Part 1: Specifications. International Electrotechnical Commission, September 2013. Accessed November 2026.